Mitsubishi Electric FR-E720-0.1K Instructions Manual page 82

(2) Inverter status/operation command
The inverter status can be monitored and operation command can be given from the master.
IND PNU
• Inverter status
Refer to ZSW on page 70 for details.
• Run command
Bit
1
2
3
0100H AH
4
5
7
8
10
12
Other than
the above
*1 Signal names are initial values. Using Pr. 180 to Pr. 184, you can change output signal functions. Refer to the
inverter manual for details of Pr. 180 to Pr. 184.
*2 Inverter reset function is invalid.
Name
Forward rotation command
(STF signal)
Reverse rotation command
(STR signal)
High-speed operation command
(terminal RH function)
*1
Middle-speed operation command
(terminal RM function)
*1
Low-speed operation command
(terminal RL function)
*1
Second function selection (RT signal)
Terminal 4 input selection (AU signal)
Output stop (terminal MRS function)
Inverter reset (terminal RES function)
−
PPO TYPE NON SUPPORT SPECIFICATION
Item
0: OFF (Stop command)
1: ON (Forward rotation
start)
0: OFF (Stop command)
1: ON (Reverse rotation
start)
Functions assigned to terminals RH, RM and RL are activated.
1: Second function is selected
1: Terminal 4 input is the main speed setting
Functions assigned to terminal MRS is activated.
*1
Functions assigned to terminal RES is activated.
*1
Not used (0 is set)
Definition
A starting command is input to the
inverter when the signal turns on.
A stop command is given when
both signals turn on simultaneously.
*2
8
75