Mitsubishi Electric FR-E720-0.1K Instructions Manual page 55

PPO TYPE SUPPORT SPECIFICATION
(2) PZD
Name

Control enable

Fault reset
(Reset)

PZD enable
STW
Forward rotation
command (STF signal)
Reverse rotation
command (STR signal)
Second function
selection (RT signal)
Output stop
(MRS signal)
RAM/EEPROM
48
Bit
0 to 2 Not used (1 is set)
0: Inverter output shutoff
3
1: Inverter output shutoff is cancelled
4 to 6 Not used (1 is set)
[At inverter error]
0: No action
1: When Pr. 349 = "0", error reset can be made in any operation mode.
7
When Pr. 349 = "1", error reset is enabled only in NET operation mode.
[When inverter is normal]
No action
8, 9 Not used (0 is set)
0: Command request of PZD is not processed. (Note that PZD enable and
command count request can be executed.)
10
1: Command request of PZD is processed.
*
At power-on or inverter reset, set 1 once.
0: OFF (Stop command)
11
1: ON (Forward rotation start)
0: OFF (Stop command)
12
1: ON (Reverse rotation start)
0: OFF
13
1: ON (Second function is selected)
0: OFF
14
1: ON (output is shut off)
0: Set frequency (HSW) is written to RAM (Power-on reset returns the
15 changed set frequency to the setting before it was written to RAM.).
1: Set frequency (HSW) is written to EEPROM.
Definition
A starting command is input to the
inverter when the signal turns on.
A stop command is given when both
signals turn on simultaneously.