Mitsubishi Electric FR-E720-0.1K Instructions Manual page 77

PPO TYPE NON SUPPORT SPECIFICATION
(2) PZD
Name
Inverter running
(RUN signal)
Forward running
Reverse running
Up to frequency
(SU signal)
ZSW
Overload alarm
(OL signal)

Output frequency
detection
(FU signal)
Fault output
(ALM signal)

HIW
70
Bit
0 : OFF
0
1 : ON (inverter running)
0 : Other than forward running
1 (during stop or reverse rotation)
1 : Forward running
0 : Other than reverse running
2 (during stop or forward rotation)
1 : Reverse running
0 : OFF
3
1 : ON (up to frequency)
0 : OFF
4
1 : ON (overload alarm)
5 Not used (0 is returned)
0 : OFF
6 1 : ON (output frequency being
detected)
0 : Inverter normal
7
1 : Inverter alarm occurrence
8 to 15 Not used (0 is returned)
0 to 15 Not used (0 is set)
Definition
• For master-to-slave messages (command
request), bits 0 to 7 are not used and must
be set to 0. The bit-wise data here do not
reflect Pr.190 to Pr.192 (output terminal
function selection).
• At command response, signals are the
same. Signals are not affected by settings
of Pr.190 to Pr.192 (output terminal function
selection).