Operation - Champion CHDS210 User Manual

Dear customer, Champion thanks you for having purchased this product CHDS210. We are convinced you will
appreciate the quality and reliability of this appliance, designed and manufactured with customer satisfaction in mind.
Instructions and warnings for safe use
Before using this appliance, carefully read the instructions and in particular the safety warnings. Keep this manual and illustrative guide with the
EN
appliance for future consultation. Should you pass the appliance on to another user, make sure to also include this documentation. NOTE: Should
certain parts of this booklet be difficult to understand or should doubts arise, contact Champion before using the product, by the address indicated
on the last page.
• After having removed the appliance from its packaging, verify its integrity based on the drawing and any presence of
damage caused by transport. If in doubt, do not use the appliance and contact an authorized service center.
• Do not let children play with the packaging! Keep the plastic bag out of the reach of children - risk of suffocation!
• Before connecting the appliance, check that the technical data (13) match the mains supply. The identification technical
data (13) is found on the appliance under the lower cover.
• This appliance must be used only for the purpose for which it was designed, namely as a vacuum cleaner for home use.
Any other use is considered not compliant and therefore dangerous.
• This appliance is not intended for persons (including children) with reduced physical, sensory or mental capabilities or
lack of experience and knowledge, if they have not been given supervision or instruction concerning the use of the
appliance in a safe way and understand the risks involved.
• Children must not play with the appliance. The appliance should not be cleaned or serviced by children without adult
supervision.
• Do NOT use the vacuum cleaner to vacuum burning ashes, liquids, sharp or hard objects, such as large glass shards or
fine powder, such as cement.
• NEVER use the vacuum cleaner without inserting the dust container and filter.
• Do NOT use the appliance with wet hands.
• Do NOT pull the power cable or the appliance itself to remove the plug from the socket.
• Do NOT expose the appliance to humidity or weather conditions (rain, sun, etc.).
• Do not put any large object in front of the openings. If any openings are blocked don not use the product. Always keep
the openings free from dust, hair etc.
• Do not use the vacuum cleaner without dust container or dust filter in place.
• Do not vacuum any flour, cement etc., in order to avoid overloading the product´s capacity.
• The appliance should only be cleaned with a dry or damp cloth. Never immerse into water. Do not use any solvents for
cleaning.
• Always disconnect the appliance from the mains supply before cleaning or performing maintenance and when the
appliance is not in use.
• If the appliance is defective, switch it off and do not tamper with it. Any repairs must only be carried out by an authorized
technical service center
• If the power cable is damaged it must be replaced by an authorized technical service center, to prevent all risks.
• NEVER pull or lift the appliance by its cable.
• NEVER submerge the appliance in water or other liquids.
• NEVER point the flexible hose, pipe or any other accessory towards another person.
• Always use the appliance with a motor protection filter to prevent damaging the motor and the vacuum cleaner.
• The power cable must always be fully unwound to prevent hazardous overheating.

Operation

1. The yellow mark on the power cord shows the ideal cable length. Do not expend the cable beyond the red mark.
2. To rewind the power cord, press the "rewind" pedal with one hand and guide the cord with the other hand
3. Press the "power" switch to turn the appliance on.
4. Use the electronic speed adjusting to control the suction power of the cleaner.
5. Set the required suction power by the electronic suction regulator. The suction power can also be adjusted with the
sliding control on the angled pipe.
If the suction flow is interrupted or the dust bag is full, the indicator lights up red.
Turn off the machine immediately, and clean the inlet filter. Empty the dust bag.
After these measures the unit can be turned on again.
Pay attention to unusual noises when using the device. This could indicate a malfunction or a blocked suction.
Parts
1: Handle
3A: Telescopic pipe adjustment button
4A: Brush position toggle switch
7: Electronic power regulator
10: Carry handle
13: Technical data
16: Dust collection system
16C: Safety interlock
17: Coupling for horizontal parking position
20: Release/locking button of the outlet filter grid 21: Accessories
21B: Upholstery nozzle
2: Air flow manual adjustment device
3B: Adjustable telescopic pipe
5: Flexible suction pipe
8: ON/Off switch
11: Suction inlet
14: Power cable
16A: Upper cover
16D: HEPA premotor filter
18: Outlet filter
21C: Dusting nozzle
3: Telescopic suction pipe
4: Combination carpet/floor brush
6: Flexible suction pipe locking buttons
9: Dust collection system release button
12: Coupling for vertical parking position
15: Automatic cable winding button
16B: Upper cover opening/locking button
16E: Dust container
19: Discharge filter grid
21A: Crevice tool
21D: Parquet brush