Operation - Champion CHDS310 User Manual

Important information
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use
of the appliance by a person responsible for their safety.
EN
• Children should be supervised to ensure that they do not play with the appliance.
• If the supply cord is damaged, it must be replaced by the manufacture or its service agent or a similarly qualified person
in order to avoid any hazard.
• This item is intended for household use only.
• Do not use the vacuum cleaner for absorbing detergent, kerosene, glass, needle, cigarette ash, water, match etc.
• The appliance should not be exposed to heat.
• Do not vacuum any moist or liquid substances and never immerse the appliance into water.
• Unplug the appliance from the mains supply socket by gently pulling the plug. Do not pull the cord, this can cause
damage to the cord.
• Do not put any large object in front of the openings. If any openings are blocked don not use the product. Always keep
the openings free from dust, hair etc.
• Do not use the vacuum cleaner without dust container or dust filter in place.
• Do not vacuum any flour, cement etc., in order to avoid overloading the product´s capacity.
• The appliance should only be cleaned with a dry or damp cloth. Never immerse into water. Do not use any solvents for
cleaning.
Assembly of the vacuum cleaner
Connect the hose to the vacuum cleaner
1. Insert flexible hose into the air-intake.
2. Press the knob until it clicks into position.
Remove the flexible hose:
1. Insert flexible hose into the air-intake.
2. Press the knob until it clicks into position.
Connect the hose to the vacuum cleaner
1. Unplug the appliance and press the knob at the end of the hose.
2. Remove it from the air-intake opening

Operation

1. The yellow mark on the power cord shows the ideal cable length. Do not expend the cable beyond the red mark.
2. To rewind the power cord, press the "rewind" pedal with one hand and guide the cord with the other hand
3. Press the "power" switch to turn the appliance on.
4. Use the electronic speed adjusting to control the suction power of the cleaner.
5. Set the required suction power by the electronic suction regulator. The suction power can also be adjusted with the
sliding control on the angled pipe.
If the suction flow is interrupted or the dust bag is full, the indicator lights up red.
Turn off the machine immediately, and clean the inlet filter. Empty the dust bag.
After these measures the unit can be turned on again.
Pay attention to unusual noises when using the device. This could indicate a
malfunction or a blocked suction.