[ 8 ] Installing the Ground Spring and Insert Guide
(1) Insert the ground spring into the boss of the upper cover, and hang the section
"A" on the hole so that the section "B" contact the end face of the roll roller shaft.
NOTE: Set the ground spring into the boss of the upper cover surely.
(2) Assemble the insert guide onto the upper cover and secure it with the one screw.
Insert guide
Ground spring
Figure 3.5-46 Installing the Ground Spring and Insert Guide
Taptite, bind B M2.6 x 8
"B"
III - 68
Roll roller shaft
Rib
Boss
Hole
Ground spring
"A"
Upper cover