ZyXEL Communications GS1200-5HP v2 User Manual page 28

The following table describes the labels in this screen.
Table 1 System
LABEL DESCRIPTION
System Information
Model Name This field displays the model name of this Switch.
Device Name This field displays the name used to identify the Switch on any network.
The device name is a link that you can click to open a screen where you can change the
name. Enter a descriptive name of up to 14 characters. Also, spaces and the following special
characters listed in the brackets ["`<>^$|&;\/:*?'] are not allowed.
Note: You must enter a descriptive name to identify the Switch.
Firmware This field displays the version number and date of the firmware the Switch is currently running.
Version
Loop Status This field displays whether the Switch is in a loop state.
MAC Address This field displays the MAC addresses of the Switch.
IP Address The Switch needs an IP address for it to be managed over the network. The factory default IP
address is 192.168.1.3.
This field displays the Switch's current IPv4 address.
Subnet Mask The subnet mask specifies the network number portion of an IP address. The factory default
subnet mask is 255.255.255.0.
This field displays the Switch's subnet mask. The subnet mask is a link that you can click to open
a screen where you can change the IP address and subnet mask.
Gateway The gateway is a router or switch on the same network segment as the device's LAN or WAN
port. The gateway helps forward packets to their destinations.
PoE Total Power This field displays the total power the Switch can provide to the connected PoE-enabled
devices on the PoE ports.
(GS1200-5HP v2
& GS1200-8HP
v2)
PoE Total Power This field displays the amount of power the Switch can still provide for PoE.
Left
(GS1200-5HP v2
& GS1200-8HP
v2)
Chapter 1 System
GS1200 Series User's Guide
28