Firmware Upgrading & Diagnostic Software - Philips DVDR9000H/75 Service Manual

EN 14 5.
3139 785 31681
5. Firmware Upgrading & Diagnostic Software
5.1 Firmware Upgrading
A. Preparation to upgrade fi rmware:
1. Unzip the zip-archive fi le
2. Start the CD Burning software and create a new CD project (data disc) with the following settings:
File system:
Format:
Recording mode:
Note: Long fi le name is necessary for the preparation of the upgrade disc
3. Place the content of the zip-archive into the root directory of the new CD project.
4. Burn the data onto a blank CDR or CD-RW
B. Procedure to apply the fi rmware upgrade:
1. Hold the <Record> + <Open/Close> buttons down and Power up the set.
2. The tray opens and set will display:
FORCE DL −>.... PUT DSC
3. Insert the prepared Upgrade CDROM and close the tray.
4. The set will display:
INIT DSC −> .......... DOWNLOAD −>..........
The whole process takes less than 15 minutes
Note: Do not press any buttons or interrupt the mains supply during the upgrading process, otherwise the set may becomes
defective.
5. When the upgrade is completed the tray will open automatically and the set will display:
REMOVE
6. Close the tray and the set will display:
DONE
C. How to read out the fi rmware version to confi rm set has been upgraded:
1. Power up the set.
2. Press <System> button on the Remote control and select {Setup} option
3. Press <Right> button to select {System}
4. The set will prompt you about clearing the Time Shift Buffer
5. Select {Yes} and press <OK> button
6. Press <Down> button several times to select {Version info}
7. Press <OK> button
8. The TV connected to the set will display:
DIF05_3/493AN SV11205
BE 43.2.13 ASP3,9,1,10FP
DTTM HW:01020102 DTTM
SW:00040200
SIT9000-FF3F-S3_F540
20051020-1815 pro sxcplusint
EPG:3.04 DPMS:P_DPM
9. Press <System> button to exit
Firmware Upgrading & Diagnostic Software
Joliet
MODE 2: CDROM XA
SINGLE SESSION (TRACK-AT-ONCE), FINALIZED CD