Firmware Upgrading & Diagnostic Software - Philips DVDR3330H/02 Service Manual

EN 12 5.
3139 785 31150
5. Firmware Upgrading & Diagnostic Software
5.1 Firmware Upgrading
A. Preparation to upgrade fi rmware:
1. Unzip the zip-archive fi le
2. Start the CD Burning software and create a new CD project (data disc) with the following settings:
File system:
Format:
Recording mode:
Note: Long fi le name is necessary for the preparation of the upgrade disc
3. Place the content of the zip-archive into the root directory of the new CD project.
4. Burn the data onto a blank CDR or CD-RW
B. Procedure to apply the fi rmware upgrade:
1. Hold the Record + Next buttons down and Power up the set to go into "Forced Download". The tray door opens automatically and
the display shows:
DOWNLOAD −>..........PUT DISC
2. Insert the prepared Upgrade CDROM and close the tray.
3. The set will display:
READING −> DOWNLOAD −>..........
The whole process takes less than 10 minutes
Note: Do not press any buttons or interrupt the mains supply during the upgrading process, otherwise the set may becomes
defective.
4. When the upgrade is completed the tray opens automatically and the set will display:
REMOVE
5. Remove the Upgrade CDROM and close the tray. The display shows:
DONE
6. The set switches automatically into Standby mode. Power off the set to complete the download process.
C. How to read out the fi rmware version to confi rm set has been upgraded:
1. Power up the set.
2. Press <System menu> button on the Remote control and select {Feature} option.
3. Press <Right> button to select {Access Control} option.
4. Press <1> <5> <9> <6> buttons in sequence.
5. The TV connected to the set will display:
AB 1.18.19 DB F05_4/53122
BE 43.2.14 SV 11203 DV 1234567890
BASE FF7_a 122_16_20050810 dev sxc 3300h rad
SpectraCORE 3300v1.13
Firmware Upgrading & Diagnostic Software
Joliet
MODE 2: CDROM XA
SINGLE SESSION (TRACK-AT-ONCE), FINALIZED CD