Code 128 Message Length
Scan the barcodes below to change the message length. Refer to
Message
Length
on page 6-1 for additional information. Minimum and Maximum
lengths = 0-80. Minimum Default = 0, Maximum Default = 80.
Minimum Message Length
Maximum Message Length
Code 128 Code Page
Code pages define the mapping of character codes to characters. If the data
received does not display with the proper characters, it may be because the
barcode being scanned was created using a code page that is different from the
one the host program is expecting. If this is the case, scan the barcode below,
select the code page with which the barcodes were created from the chart,
Code
Page Mapping of Printed barcodes
on page A-4, and scan the value and the
SAVE barcode from the
Programming Chart
inside the back cover of this
manual. The data characters should then appear properly.
Code 128 Code Page
Code 128 Function Code Transmit
By default, Code 128 function codes are not transmitted with Code 128 barcode
data. However, if you wish to transmit Code 128 function codes with the barcode
data, scan the Function Codes On barcode, below.
* Function Codes Off
Function Codes On
Telepen
<Default All Telepen Settings>
6 - 14
3200 User's Guide