Plug And Play; Connecting The Imager When Powered By Host (Keyboard Wedge) - Honeywell 3200 User Manual

Plug and Play

Plug and Play barcodes provide instant imager set up for commonly used
interfaces.
Note: After you scan one of the codes, power cycle the host terminal to have the
interface in effect.
Connecting the Imager When Powered by Host
(Keyboard Wedge)
An imager can be connected between the keyboard and PC as a "keyboard
wedge," plugged into the serial port or connected to a portable data terminal.
The following is an example of a keyboard wedge connection:
1. Turn off power to the terminal/computer.
2. Disconnect the keyboard cable from the back of the terminal/computer.
3. Connect the appropriate interface cable to the imager and to the terminal/
computer.
4. Turn the terminal/computer power back on.
Note: You will not hear a power-up beep because the 3200 linear imager is
factory defaulted to a USB connection. You must scan the
and Compatibles with CR suffix
wedge ability.
Verify the imager operation by scanning a barcode from the
the back of this manual. The imager beeps once.
3200 User's Guide
barcode on page 1-4
IBM PC AT
to enable keyboard
Sample Symbols
1 - 3
in