2
Terminal Interfaces
Terminal ID
If your interface is not a standard PC AT, refer to
Terminal
ID, beginning on page
2-1 and locate the Terminal ID number for your PC. Scan the Terminal ID
barcode below, then scan the numeric barcode(s) from the
Programming Chart
inside the back cover of this manual to program the imager for your terminal ID.
Scan Save to save your selection.
For example, an IBM AT terminal has a Terminal ID of 003. You would scan the
Terminal ID barcode, then 0, 0, 3 from the
Programming Chart
inside the back
cover of this manual, then Save. If you make an error while scanning the digits
(before scanning Save), scan the Discard code on the
Programming
Chart, scan
the Terminal ID barcode, scan the digits, and the Save code again.
Terminal ID
Save
Note: After scanning one of these codes, you must power cycle your computer.
3200 User's Guide
2 - 1