Measurement - PCE Health and Fitness PCE-COM 20 User Manual

5.2

Measurement

By pressing the „MEAS" key, you can directly enter measurement mode from the welcome
screen, from the calibration menu or from the settings screen (Image 2).
Notes

In the upper area of the display (cf. „MEASUREMENT") Image 2), you can
see in what mode you currently are.

The battery icon

In the middle of the display, you can see the conductivity value of the tested
sample at +20°C in the unit MS/m or % IACS (if you want to change the
unit, please see „DEL/UNIT" at the bottom of this page and chapter 5.4.7 of
this manual).

In the lower area of the display on the left-hand side, you can find the
conductivity value "σ(28) = ..." at the current temperature. The unit of
measurement is identical with the unit in the middle of the display at 20 °C.
The value within brackets shows the compensated temperature. Further
information about this can be found in chapter 5.4.3.

"TA = ...°C" at the bottom of the display on the left-hand side shows the
current ambient temperature.

In the lower, right-hand area of the display, "f = ... kHz" shows the operating
frequency of the probe.

In the lower right corner, "a
the tested sample. Further information about this can be found in chapter
"5.4.4".
To change the unit of measurement, press the "DEL/UNIT" key. With each keystroke, the device
changes to the other unit or format. When you switch on the device again or have left
measurement mode, the unit will automatically change back to the unit originally set.
Image 2
shows the remaining battery power.
" shows the current temperature coefficient of
0
© PCE Instruments
8