Removing Sdio Cards - DAP Technologies CE8640B User Manual

USING SDIO CARDS (CONTINUED)
WArNING
The Application may not allow the removal of an SDIO Card while it is running . Refer to your Supervisor, the
application provider or a DAP Technologies Representative for further instructions .

Removing SDIO Cards

1 . Turn the unit off .
2 . Using a Flathead Screwdriver remove the
four screws located on either side of the
SDIO Card Expansion Bay .
3 . Remove Expansion Bay .
4 . Remove stopper .
5 . Remove SDIO Card .
6 . Replace Expansion Bay and tighten screws .
7 . Re-install stopper
WArNING
• Remove SDIO Cards in a clean and dry
environment to ensure no dust particles or
water enters the unit .
www.daptech.com
Operation Guide
CMU055-A2a 31