Table of Contents
Advertisement
CHARGING THE BATTERY (CONTINUED)
From the External Charger (Continued)
Note: The CE8000B Battery Status indicator
will turn red in the next 5 seconds indicating that
charging is now in progress . The light will turn
green when charging is complete . Charging may
take up to 5 hours .
Note: If the unit was turned off, it should turn back
on after a few seconds or after 2 to 3 minutes if the
main battery charge has been very low for some
time . Processing will resume exactly where it was
interrupted once re-charging starts .
WArNING
If the charge indicator (LED) flashes, a problem has occurred during the charging or the battery temperature
has exceeded its safe charging range of +5°C (41°F) to + 45°C (113°F) . Remove the battery from the charger,
disconnect the charger for 5 to 10 seconds to remove the error status and try charging again . (If the problem
persists, contact a Customer Service Representative nearest you) .
Battery Status Indicator Color Definition
Color
Definition
red
Charger is connected and charging .
Green
Battery is fully charged .
Blinking red
Warning, low battery
Yellow
Charger detected, but the battery charger temperature is too high or too
low to re-charge . Charge will start when temperature is adequate .
Blinking Yellow
Charging disabled by the application program .
No Light
Power from the charger is not detected .
20
Getting Started
Battery Status indicator on CE8640B
Battery Status indicator on CE8800B
CMU055-A2a
www.daptech.com
Advertisement
Table of Contents
