Table of Contents
Advertisement
TURNING THE UNIT ON & OFF
Once charging is complete, the unit will automati-
cally turn itself off after approximately 3 minutes .
Turn Unit On
1 . To turn on the CE8640B unit, press on
the ON button for about 2 to 3 seconds .
2 . To turn on the CE8810B or the CE8820B .
Press the ON key located at the back of the
unit .
Note: This key has two (2) functions:
1) To turn the unit ON .
2) To use Scanner (Laser Scanner Key) .
WArNING
If the battery power level is very low, it may not be
possible to turn the unit on . Ensure battery is fully
charged .
Turn Unit Off Manually
1 . Click on the Start Button located at the
bottom left corner of your screen .
2 . Click suspend .
Note: This above instruction is valid for the entire
CE8000B series .
Turn Off the CE8640B Unit
1 . Click on the blue key followed by the ON/OFF
key; one after the other .
www.daptech.com
Operation Guide
+
CMU055-A2a
21
Advertisement
Table of Contents
