Table of Contents
Advertisement
CHARGING THE BATTERY (CONTINUED)
From the Communication Cradle
1 . Cradles are available for office and vehicle
use . The installation requires a Modular
Charger available from DAP Technologies .
2 . Before charging the CE8000B unit, you must
first power up the Communication Cradle .
3 . Insert the round connector of the Modular
Charger into the round connector of the cradle .
4 . Connect the Modular Charger to the wall outlet .
5 . Slide unit into the cradle, bottom first (a) . (The
unit will be firmly held into place by the yel-
low hooks located at the top of the cradle (b)) .
6 . Once charging is complete, remove the unit by
pushing the yellow release button (a) .
7 . Slide unit upwards to remove (b) .
WArNING
Ensure unit is inserted correctly onto cradle or
charging will not occur and charging pins could be
damaged .
18
Getting Started
Modular Charger
for Office Cradles
CMU055-A2a
Modular Charger for
Vehicle Cradles
1) CS512 with a 240
CSCE800-NA
cm (95 in) power cable
CSCE800-EU
CSCE800-UK
b
a
a
b
www.daptech.com
Advertisement
Table of Contents
