Table of Contents
Advertisement
USING SDIO CARDS
WArNING
The Application may not allow the insertion of an SDIO Card while it is running . Refer to your
Supervisor, the application provider or a DAP Technologies Representative for further instructions .
Inserting SDIO Cards
1 . Turn the unit off .
2 . Using a Flathead Screwdriver remove the four
screws located on either side of the PC Card
Expansion Bay .
3 . Remove Expansion Bay .
4 . Remove the stopper .
5 . To insert a SDIO Card, slide it gently into the
socket . Once inserted completely, the SDIO
Card will lock into place .
6 . Place stopper to secure SDIO Card firmly into
place .
7 . Replace the door to its original position and
tighten screws .
WArNING
•
Ensure to place SDIO Card as indicated on the
right or you may damage the unit or PC Card .
•
Insert SDIO Card in a clean and dry environment
to ensure no dust particles or water enters the unit .
30
Operation Guide
CMU055-A2a
www.daptech.com
Advertisement
Table of Contents
