Table of Contents
Advertisement
1. HOW TO INSTALL THE UNIT
1.3
IP Handset
The IP handset functions as a display and it may also be used for normal voice com-
munication. The units (max 26 units) may be installed anywhere onboard the vessel.
The IP handset is provided with a cradle. Fix the cradle to the bulkhead or installation
panel. The cradle has two cable entries for convenience; bottom and rear.
1. To use the rear cable entry, make a hole of 18 mm (0.71") diameter in the instal-
lation site, Refer to the outline drawing.
2. Remove four screws from the cradle to separate the plastic case from the metal
plate.
3. Fix the metal plate to the mounting site with four self-tapping screws.
4. Connect the LAN cable from the CU to the inner RJ45 port in the cradle.
5. If the bottom cable entry is used, run the LAN cable as shown in the figure below
and fix it with a cable-tie.
6. Reattach the plastic cover.
7. Connect the cable from the handset to the outer RJ-45 port of the cradle.
A
1-12
59
Cable entry
(bottom)
CRADLE
VIEW A
(2.32")
Metal plate
35±0.5
RJ45
Metal plate
Cable from the handset
4-
4
ø
Fixing holes
Cable entry
from the CU
(Rear)
(1.38")
4-
4
ø
Fixing holes
18 (0.71")
ø
Cable entry
(rear )
Fix with a cable-tie
Cable from the CU
(Bottom)
Advertisement
Table of Contents
