13 Messages and Corrective Actions
Code
Message
43
Aborted the auto deskew processing.
44
Auto deskew cannot be executed in
the following cases.
• When the trigger type is not Simple
• When the trigger type is Simple and the source is Ext or Line
• When Trigger Source = Deskew Target CH
• When Deskew Target CH is Pod A or Pod B
45
Auto deskew is in progress.
46
Cycle measure is not executed.
873
Invalid math operation.
874
Invalid math source.
875
Invalid measure item.
* See the DL7440/DL7480 User's Manual IM701450-01E .
48
This section contains only the status and error messages that have been added for the
Power Analysis Function (/G4 Option). For a description of the standard messages see
section 16.2 in the DL7440/DL7480 User's Manual IM701450-01E or appendix 2 in the
DL7440/DL7480 Communication Interface User's Manual IM701450-17E (CD-ROM).
Corrective Action
–
–
Wait until auto deskew completes.
Execute Cycle measure of the trend target item before
displaying the trend waveform.
Check the math operation that you are trying to specify. Chapter 7
Check the math source that you are trying to specify.
Check the measurement item that you are trying to
specify.
Reference Section
Chapter 4
Chapter 4, *
Chapter 4
Chapter 8
Chapter 7
Chapter 5,
Chapter 7 to 10
IM 701450-61E