Hitachi ZX27U-2 Operator's Manual page 67

Tuning Procedure
1. Tap the TUNE ∧ button (9) to increase the frequency.
Tap the TUNE ∨ button (9) to decrease the frequency.
Tap and hold the button to change the frequency
continuously.
2. Automatic Tuning
Press this button to automatically move the frequency
up and to seek a receivable station. When a station is
received, the auto-seeking function is deactivated so
that the received frequency station is tuned in.
Station Presetting Procedure
1. Select MW (AM) or FM by pressing BAND button (8).
Select a station by pressing either TUNE button (9) or
SEEK button (7).
2. Continuously press one of PRESET button (6) by
which you desire to preset the station for more than 2
seconds. When presetting is complete, the preset
button No. is indicated on the display.
3. Repeat the above same procedure steps (1) and (2)
to preset other stations with other PRESET buttons
(6).
NOTE: After presetting is complete, if the preset button
is pressed again and held for more than 2
seconds, the preset station is changed.
•
Auto-Storing
Press and hold the AST button (5) for more than 2
seconds with the radio switch ON, preset buttons (1 to
6) automatically search receivable frequency stations
in the selected frequency band (AM or FM) and
memorize each station in one button.
NOTE: When auto-store operation is made, the pre-
ciously memorized stations are deleted. If it is
difficult to set the memory of the desired station
to the desired button, conduct preset operation.
•
Preset Scanning
Press and release the AST button (5) in 2 seconds
with the radio switch ON, preset station frequencies
are received one by one for 5 seconds. Press the
button again to resume normal radio operation.
Deletion of Preset Memory
If the battery power is disconnected such as when the
machine is serviced or the radio is removed, the preset
memory in the preset buttons will be deleted. Repeat the
preset operation again.
OPERATOR'S STATION
1-17
2
1 3
2
1 3
6 9
8 5 7 4
M1M7-01-011
6 9
8 5 7 4
M1M7-01-011