•
Set Time Change
1. Turn the key switch ON. Display the trip meter you
wish to change the set time by operating display se-
lection switch (5). The trip meter will display the re-
maining time until the trip mark starts flashing at this
time.
2. Press set switch (4) once. The remaining time display
can be changed as follows:
Present Display
Time
35.2
184.7
3. When set switch (4) is pressed further, the set time
will be changed as follows each time the switch is
pressed.
50>100>150>200>250>300>400>500>750>1000>12
50>1500>2000>2500>3000
When the set switch is pressed for more than 2 sec-
onds, the set-hour will be quickly shifted.
4. After the time you wish to change to, is displayed,
press display selection switch (5) to reset the trip
meter.
IMPORTANT: Once the set time is changed, the trip
meter restarts counting down the time.
Accordingly, note that the displayed time
is different from the operation hours
counted from the first-set time.
•
When no trip meter is used:
When no trip meter is used, set the trip meter for a suffi-
ciently long time (example: 3000 hrs) by following the
procedures described above.
NOTE: The trip meters are set at 10000 hours when the
machine is shipped from the factory.
OPERATOR'S STATION
Time to be Displayed After
being Changed
→
50.0
→
200.0
ZX30U
Trip Mark
When Trip meter 1 is displayed
Trip Mark
When Trip meter 2 is displayed
1-10
ZX27U
-2
, ZX35U
ZX40U
, ZX50U
-2
-2,
-2
3
4
5
M1M7-01-031
3
4
5
M1M7-01-028
-2
M1SM-01-006
M1SM-01-007