Challenge Titan 265 Instruction Manual page 57

8.0 Maintenance Guide
5. CLAMP PRESSURE: The clamp pressure is adjusted remotely from the console with the up
and down arrow keys. It is shown in the upper left corner of the display, on a scale of 0 to 15,
with 0 being the lightest pressure and 15 the highest.
NOTE: To turn the electronic clamp control option on or off, enter the Maintenance Mode and choose
Diagnostic. Then choose Electric Clamp and select "ON" or "OFF".
To adjust the actual clamp pressure maximum and minimum, first make sure the Electric Clamp
option is set to "ON" (see above paragraph). Enter the Maintenance Mode and choose Diagnostic.
Then choose Clamp Adjust, and the following screen should be displayed:
Now perform a cut cycle. After the clamp has contacted the table and while the knife bar is coming
down, read the pressure on the right hand pressure gauge. It should read 900 psi. If it does not,
correct by using the up and down arrow keys. When finished, press soft-key "D" to exit and go to the
minimum pressure set up screen shown below:
Perform a cut cycle. After the clamp has contacted the table and while the knife bar is coming down,
read the pressure on the right hand pressure gauge. It should read 400 p.s.i. If it does not, correct
by using the up and down arrow keys. When finished, press soft-key "C" to return to Send Mode, or
soft-key "D" to return to Diagnostics.
56
5.000
Set Maximum
>
Press /\ to Increase
Press \/ to Decrease
A) Main C) Send
B) Job D) Exit
5.000
Set Minimum
>
Press /\ to Increase
Press \/ to Decrease
A) Main C) Send
B) Job D) Exit