Challenge Titan 265 Instruction Manual page 14

Remove the front tilt cover (if installed) and the sheet metal covers from the rear of the table.
Remove the backgauge motor cover, the lower back panel, and the lower front cover of the machine.
Also remove the table extensions and 2-hand button controls (if equipped).
Unplug the cable to the encoder at the back of the machine (Figure 4). Remove the motor junction
box cover and disconnect the wires to the motor (Figure 4). Remove the leadscrew cover and the
nylon tyraps that are attached to the bottom of the table. The motor wires and encoder wires should
now be free from the table.
Remove the preset board assembly from the bottom of table (Figure 5).
Open the top hood and loosen the jam nut on left hand side guide support screw and turn it in a few
turns for clearance, then remove the left and right side guides as shown in Figure 6 & Figure 7 on
page 14.
Motor
Jcn. Box
Figure 4
Preset Board
Assembly
Figure 5
5.0 Installation & Setup
Encoder
Plug
13