Challenge Titan 265 Instruction Manual page 31

6.0 Operation
6.13.4.1 Entering Send Values
Now enter send values by using any of the following methods: 1) Type in the desired value and press
ENTER, 2) Press ENTER at a blank line - this will enter the current position of the backgauge as a
send value, or 3) Use the "Cut and Record" feature as described below.
When finished entering send values you may exit the current job by pressing soft-key "B" (Job) to go
back to the job mode screen or soft-key "D" (Exit) to exit to send mode. Or you may use the current
job for cutting by pressing the down arrow at the last line and following the instructions in the
"Running a Job" section (pg. 23).
6.13.4.2 Cut and Record
To use this feature, send the backgauge to a desired position using the backgauge glide control or by
using SEND, then make a cut. The current backgauge position will automatically be entered into the
job as a send value. This can be very convenient for setting up a program when the actual cut
positions are not known.
6.13.4.3 Channel Linking
If more than 35 cut values are needed (99 channels on s/n 001276 and up), 2 channels can be linked
together into one job providing up to 70 (198 on s/n 001276 and up) cut values. This is done
automatically when a job is at 35 cuts (99 on s/n 001276 and up) and an attempt is made to add
another value. At this point, a screen is displayed asking: do you want to link to the next channel?
Use the up or down arrow key to select yes or no. If no is selected, the last cut will be discarded and
the new value will be inserted. If yes is selected, the last cut will be pushed into the first value of the
next channel, although it will be displayed as value 36 of the current channel (or 100 on s/n 001276
and up). If the next channel is locked, linking will not be allowed. NOTE: If the next channel is not
locked, but contains data, the old data WILL BE LOST. After 2 jobs have been linked, the linked job
will be displayed as "^^^^^^^^" and will be locked.
To unlink a job, use the up or down arrow key to point to the linked job name and press soft-key "C"
(Erase).
When finished entering send values you may exit the current job by pressing soft-key "B" (Job) to go
back to the job mode screen or soft-key "D" (Exit) to exit to send mode. Or you may use the current
job for cutting by pressing the down arrow at the last line and following the instructions in the Running
a Programmed Job section on page 31.
30
5.000
in
1> _
A) Insert C) Erase
B) Job D) Exit
#1