Challenge Titan 265 Instruction Manual page 37

7.0 Knife Installation/Changing
3. Remove the knife bolts from the two slotted knife bar holes and replace with the knife lifters
(Figure 20).
bolts.
4. Clear the table surfaces and place the empty knife scabbard on the table. Remove the
scabbard's knife retaining screws.
5. Grasp the knife lifters firmly and, at the same time, turn them counterclockwise to release the
knife from the knife bar (Figure 21 on page 37). Lower the left end first, then lower the right
end as you shift the knife sideways to the left. Bring the right end of the knife out from the
machine. Shift the knife to the right and bring out the left end. Put the blade in the scabbard
immediately and secure the knife retainer screws.
36
Knife Adjusting Screws
Tighten the lifters to hold the knife in place, and then remove the remaining knife
Figure 19
Figure 20