Challenge Titan 265 Instruction Manual page 34

Now press ENTER to begin programming the job. The display should now look similar to the one
shown next:
4. To enter the first send value of 8.5", simply type in 8.5 and press ENTER. The cursor will
move to the second line. Now type 11 and press enter.
At this point, you could exit and save the job by pressing the soft-key "D" (Exit) to exit to send mode,
or the soft-key "B" (Job) to exit back to the job mode screen. However, lets use this job to cut paper.
5. Press the down arrow key once. This will remove the blank line 3 and move the cursor to the
first send value (8.5"). Now press SEND. This will move the backgauge to the 8.5" position.
Place the paper to be cut against the backgauge, close the front guard, and press the cut
button. Once the cut cycle is complete, the backgauge will push out the paper and move to
the next send value (11"). Now position the paper again, close the guard, and make another
cut. After the cut is made, the backgauge will push out the stock and return to the first cut
position, ready to repeat the current job.
6. Now lets lock the current job so it cannot be edited. First, exit back to job mode by pressing
soft-key "B" (Job). Now move the cursor down to the new job using the down arrow key.
Now press the soft-key "A" (Lock) to lock the job. An asterisk will appear indicating the job
has been locked.
7. To exit back to send mode, press the soft-key "D" (Exit).
5.000
in #7
1> _
A) Insert C) Erase
B) Job D) Exit
5.000
in #7
1> 8.500
2> 11.000
3> _
A) Insert C) Erase
B) Job D) Exit
6.0 Operation
33