Yamaha CS-700 Operation Manual page 66

Property Type
net.dot1x-enabled BOOLEAN
net.dot1x-identity TEXT
net.dot1x- TEXT
password
net.dot1x-auth- OPTION
method
net.dot1x- TEXT
anonymous-
identity
net.dot1x-phase1 TEXT
net.dot1x-phase2 TEXT
voip.registrar TEXT
voip.registrar- TEXT
backup
voip.realm TEXT
voip.proxy TEXT
Values
0 : Disable 802.1x authentication
1 : Enable 802.1x authentication
username : String.
password : String.
MD5 : MD5 authentication
method
PEAP : PEAP authentication
method
method : String. Anonymous
identity.
Authentication phase 1 string
Authentication phase 2 string
IP address or DNS name.
IP address or DNS name.
Realm string.
IP address or name. Separate
multiple addresses by a comma.
Add ";lr" suffix for loose routing.
Default Value Description
0 Enables 802.1x authentication to access the network. When
enabled, the 802.1x authentication type and the required
credentials also need to be specified. MD5 authentication requires
a username and password. Protected EAP (Protected Extensible
Authentication Protocol) uses a public-private key mechanism to
authenticate devices. You will need to install onto your UC device
the server-side public key certificate, and you need to specify an
anonymous identity, username and password.
Set a 802.1x authentication identity – required for MD5 and PEAP.
Set a 802.1x authentication password – required for MD5 and
PEAP.
MD5 The 802.1x authentication method, either MD5 or PEAP.
Set a 802.1x authentication anonymous identity – required for
PEAP.
Configure 802.1x authentication phase 1 string.
Configure 802.1x authentication phase 2 string.
The IP address or DNS name of the SIP registrar server. Required
for VoIP call support.
The IP address or DNS name of a failover SIP registrar.
* Realm of the credential to authenticate against the VoIP server.
The value here must match the realm sent by the server in the
WWW-Authenticate or Proxy-Authenticate header in the 401/407
response. An asterisk ('*') causes the endpoint to respond to any
realms.
The outbound SIP proxy server's IP address or name. If there are
multiple SIP proxies, separate the addresses by a comma. Also
note that if the allow strict routing option is set and you have a SIP
proxy that is configured for loose routing, add the designation
after the proxy's address, for example, '10.134.129.101;lr'.
66