Garage Door Opener - If Equipped; Before You Begin Programming Homelink - Jeep Cherokee 2019 Owner's Manual

GARAGE DOOR OPENER — IF EQUIPPED
HomeLink replaces up to three hand-held transmitters that
operate devices such as garage door openers, motorized
gates, lighting or home security systems. The HomeLink
unit is powered by your vehicle's 12 Volt battery.
The HomeLink buttons, located on the driver's side sun
visor, designate the three different HomeLink channels.
The HomeLink indicator is located above the center button.
HomeLink Buttons On Sun Visor
NOTE: HomeLink is disabled when the Vehicle Security
Alarm is active.
GETTING TO KNOW YOUR VEHICLE 115

Before You Begin Programming HomeLink

Be sure that your vehicle is parked outside of the garage
before you begin programming.
For more efficient programming and accurate transmission
of the radio-frequency signal it is recommended that a new
battery be placed in the hand-held transmitter of the device
that is being programmed to the HomeLink system.
To erase the channels, place the ignition in the ON/RUN
position, and push and hold the two outside HomeLink
buttons (I and III) for up to 20 seconds or until the orange
indicator flashes.
NOTE:
• Erasing all channels should only be performed when
programming HomeLink for the first time. Do not erase
channels when programming additional buttons.
• If you have any problems, or require assistance, please
call toll-free 1-800-355-3515 or, on the Internet at
HomeLink.com for information or assistance.
3