To Manually Turn On The Stop/Start System; System Malfunction; Speed Control - If Equipped - Jeep Cherokee 2019 Owner's Manual

288 STARTING AND OPERATING
4. The STOP/START system will reset itself back to the ON
mode every time the ignition is turned off and back on.

To Manually Turn On The Stop/Start System

Push the STOP/START Off switch (located on the switch
bank). The light on the switch will turn off.

System Malfunction

If there is a malfunction in the STOP/START system, the
system will not shut down the engine. A "SERVICE STOP/
START SYSTEM" message will appear in the instrument
cluster display. Refer to "Warning Lights And Messages" in
"Getting To Know Your Instrument Panel" for further
information.
If the "SERVICE STOP/START SYSTEM" message appears
in the instrument cluster display, have the system checked
by your authorized dealer.
SPEED CONTROL — IF EQUIPPED
When engaged, the Speed Control takes over accelerator
operations at speeds greater than 25 mph (40 km/h).
The Speed Control buttons are located on the right side of
the steering wheel.
Speed Control Buttons
1 — On/Off
2 — SET (+)/Accel
3 — RES/Resume
4 — SET (-)/Decel
5 — CANC/Cancel