Martin MAC 2000 WASH BARNDOORS User Manual page 16

16 Push the roller (not the spring-load bolt) at position D until it is locked into position.
17 Push the roller (not the spring-loaded bolt) at position F until it is locked into position.
F
18 Move the rotation assembly (I) from stop-to-stop several times to ensure that it moves smoothly and without
hindrance. If this is not the case then the rotation assembly is probably not installed correctly; remove the
lens and repeat the re-assembly steps in this procedure.
19 Replace the front and rear casings by replacing the Phillips screws at each corner.
16
D
MAC 2000 Wash Barndoors