EMC CX3-10 Field Installation Manual page 19

Installing latch brackets and bezel
Figure 12
EMC Rails and Enclosures (CX3-10 Class and CX3-20 Class Storage Systems) Field Installation Guide
This section describes how to install latch brackets and the bezel they
support.
1. Use one Phillips M5 x 16-mm screw to secure a latch bracket to
each front channel. (The brackets include small alignment bumps
to correctly orient them to the channel.) See
2. Press the bezel onto the latch brackets until it snaps into place. See
Figure 12.
Latch
Bracket
Front
Installing the latch bracket and bezel
Installing a 1U SPS tray and SPS units in a cabinet
Rear
Latch
Bracket
Figure 12.
EMC3250
19