EMC CX3-10 Field Installation Manual page 17

Installing the SPS tray in the cabinet
Figure 10
Installing the SPS units in an SPS tray
EMC Rails and Enclosures (CX3-10 Class and CX3-20 Class Storage Systems) Field Installation Guide
This section describes how to install the tray in the rackmount
cabinet.
1. From the front of the cabinet, align the SPS tray with the channels
on the mounting rails. Position the tray as shown in
2. Slide the tray onto the mounting rails in the cabinet, until the
flanges of the tray are flush with the cabinet channels. See
Figure 10.
Inserting the SPS tray in the cabinet
3. Do not insert any new screws, but tighten the four securing
screws (two on each side - see
rails to the channels.
You have installed an SPS tray. Continue to the next section to install
SPS units.
1. Remove the SPS units from their packaging.
2. Working from the front of the cabinet, slide the SPS units onto the
tray as shown in Figure
Installing a 1U SPS tray and SPS units in a cabinet
Rear
EMC3252
Figure 9) that hold the mounting
11.
Figure 10.
17