Electrical Connection; Operation - Lenze SMVector Installation And Operation Manual

1.1.4

Electrical Connection

When working on live drive controllers, applicable national regulations for the prevention of accidents (e.g.
VBG 4) must be observed.
The electrical installation must be carried out in accordance with the appropriate regulations (e.g.
cable cross-sections, fuses, PE connection). Additional information can be obtained from the regulatory
documentation.
The regulatory documentation contains information about installation in compliance with EMC (shielding,
grounding, fi lters and cables). These notes must also be observed for CE-marked controllers.
The manufacturer of the system or machine is responsible for compliance with the required limit values
demanded by EMC legislation.
1.1.5

Operation

Systems including controllers must be equipped with additional monitoring and protection devices according
to the corresponding standards (e.g. technical equipment, regulations for prevention of accidents, etc.).
You are allowed to adapt the controller to your application as described in the documentation.
Pictograph
SMVector I/O Module ALSV01 v1.0 13376253
Safety Information
DANGER!
• After the controller has been disconnected from the supply voltage, do not touch the live components
and power connection until the capacitors have discharged. Please observe the corresponding
notes on the controller.
• Do not continuously cycle input power to the controller more than once every three minutes.
• Close all protective covers and doors during operation.
WARNING!
Network control permits automatic starting and stopping of the inverter drive. The system design must
incorporate adequate protection to prevent personnel from accessing moving equipment while power is
applied to the drive system.
Table 1: Pictographs used in these instructions
Signal word
Warning of Hazardous
DANGER!
Electrical Voltage.
Impending or possible
WARNING!
danger for persons
STOP!
Useful tip: If observed, it will
NOTE
make using the drive easier
Meaning
Reference to an imminent danger that may
result in death or serious personal injury if
the corresponding measures are not taken.
Possible damage
to equipment
6
Consequences if ignored
Death or injury
Damage to drive system
or its surroundings