Table of Contents
Advertisement
18
Getting started
To use your Bluetooth headset, follow these simple
steps:
•
Charge your headset battery.
•
Turn your headset on.
•
Pair your headset with your Sendo X phone.
•
Wear your headset
!
To charge the battery
z Note:
The battery pack for your Bluetooth
headset is already installed when you purchase
your headset. If the battery pack has been
removed, or for instructions on re-installing the
battery, see
on Page
153.
1. Connect the Sendo X phone charger to the
mains power supply and then to the headset
charger connector.
2. Within a few seconds, the indicator light will
illuminate red. The indicator light will turn green
when the headset is fully charged.
Charge the headset overnight or for at least 8 hours
before first use. Subsequent charges take
approximately 90 minutes.
Replacing or installing a new battery
When the headset is on and the battery becomes
low, the headset emits a beep every 20 seconds. The
indicator light also flashes red when the battery
needs to be recharged. Recharge the battery as
described above.
z Tip:
Fully draining the battery once a month can
improve battery life. Otherwise, it is best to
charge your headset whenever possible. Avoid
charging in excessive heat (above 104ºF/40ºC)
or cold (below 50ºF/10ºC).
The headset can also be charged using the Sendo X
phone in-car charger (supplied separately).
!
To turn your headset on/off
1. Unplug your headset from the charger and then
press and hold the power/mute button until the
indicator light flashes green.
2. The indicator light will flash green every 2-3
seconds whilst the headset is on.
3. To turn your headset off, press and hold the
power/mute button until the indicator light turns
red.
149
Sendo X User Guide
Advertisement
Table of Contents
