Pc/Printer Port; Ethernet Port - ABB CP650-x Operating Instructions Manual

PC/Printer Port

The PC/printer port can be used to communicate with the PLC or with another type of controller.
Different electrical standards are available for the signals in the PLC port connector: RS-232, RS-422,
RS-485. The used cable selects the appropriate signals.
It is always necessary to use the correct cable type to connect on the PLC.
If the proper cable is not used, communication with the PLC will not be possible.
NOTE
The connector is a DB-9 pin female.
Pin Description
1 GND
2
3 TX/CHA-
The communication cable must be chosen for the type of device being connected.

Ethernet Port

Ethernet Port
A
OFF: No activity
BLINKING: Activity
Pin Description
1 TX OUT +
2 TX OUT -
Operating Instructions
Pin Description
4 RX/CHB-
5
6 +5 V output
B
ON: Valid link hast NOT been detected
OFF: Valid link has been detected
Pin Description
3 RX OUT +
4
Pin
7
8
9
Pin Description
5
6 RX OUT -
16
Description
CTS/CHB+
RTS/CHA+
Pin Description
7
CP600/Issue: 12.2011