Getting Started - ABB CP650-x Operating Instructions Manual

Getting Started

The Control Panels must be programmed with the programming package PB610 Panel Builder 600.
The Control Panels are programmed via the Ethernet interface.

The Control Panel must be in configuration mode to be programmed.
 To program a Control Panel connect the Control Panel to a PC running PB610 Panel Builder 600
software package.
The software package PB610 Panel Builder 600 is a Windows
stalled. The Windows
and must already be installed on the PC.
PB610 Panel Builder 600 uses the PC Ethernet interface to communicate with the target device.
 Make sure that the proper firewall policy is configured in order to allow PB610 Panel Builder 600 to
access the network.
The version of the Panel Builder used must be compatible with the PB610 Panel Builder 600 Runtime
version installed on the Control Panel to be programmed. Check with technical support for more informa-
tion on compatibility between firmware and programming software.
Operating Instructions
TM
environment is not included in the software package PB610 Panel Builder 600
TM
application and must be properly in-
21
CP600/Issue: 12.2011