At^sstgi Remote-Sat Get Information - Setup Menu (37) - Siemens MC35 Terminal User Manual

Remote-SAT User's Guide
P R E L I M I N A R Y
1.4.14 AT^SSTGI Remote-SAT Get Information – Setup Menu (37)
Write command
This command is mainly to be used upon receiving an unsolicited result code
^SSTN:37. However, please refer to note below.
AT^SSTGI=37
The response provides the main menu of the SIM Application to the TA. This is
stored by the TA so that it can be displayed without invoking a proactive session.
Note:
As with every proactive command the TA is expected to acknowledge the
^SSTGI response with AT^SSTR to confirm that the proactive command has
been executed.
Terminal Response via AT^SSTR will not provide any user information in case
of this proactive command. Refer to "AT^SSTR Remote-SAT Event Response
– Menu Selection (211)", pg. 55
Response
The first line of output from the ME is:
^SSTGI: <cmdType>, <commandDetails>, <numOfItems>, <titleText>,
<menuItemIconsPresent>, <menuItemIconsQualifier>, <titleIconQualifier>,
<titleIconId> <CR> <LF>
One line follows for every menu item, repeated for <numOfItems>:
^SSTGI: <cmdType>, <itemId>, <itemText>, <nextActionId>, <iconId> <CR>
<LF>
Parameters
<cmdType>
<commandDetails>
<titleText>
<menuItemIconsPresent>
<menuItemIconsQualifier> Unsigned Integer, range 0 – 255, used as a bitfield.
<titleIconQualifier>
MC35_SAT_01_V01.01a - Preliminary
37 – Proactive command ID, see Table 1
Unsigned Integer, range 0 – 255, used as a bitfield.
bit 1: 0 = no selection preference
1 = selection using soft key preferred
bits 2 to 7: = RFU
bit 8: 0 = no help information available
1 = help information available
String displaying menu title
0 = no Icons
1 = Icons present
bit 1: 0 = icons are self explanatory and replace text
1 = icons are not self-explanatory and shall be
displayed with the text
Determined value only if associated icon id is
not 0 (an icon exists).
bits 2-8: = RFU
Unsigned Integer, range 0 – 255, used as a bitfield.
bit 1: 0 = icon is self explanatory and replaces text
1 = icon is not self-explanatory and shall be
displayed with the text
Determined value only if associated icon id is
not 0 (an icon exists).
Page 37 of 64 15.11.2001