At^sstr Remote-Sat Response - Generic Format - Siemens MC35 Terminal User Manual

Remote-SAT User's Guide
P R E L I M I N A R Y
1.5 AT^SSTR Remote-SAT Response – Generic Format
Test command Response
AT^SSTR=?
^SSTR:(list of supported <state>s), (list of supported <cmdType>s)
OK
Read command Response
AT^SSTR?
^SSTR: <state>, <cmdType>
OK
Parameters
<state>
<cmdType> Ongoing Proactive Command (values see chapter 1.1.4
Write command The TA is expected to acknowledge the ^SSTGI response with AT^SSTR to
confirm that the proactive command has been executed.
AT^SSTR=
AT^SSTR will also provide any user information e.g. selected menu item.
<cmdType>,
<status>
[,<itemId>]
Response
[,<inputString>]
If an error occurs during execution of a Proactive Command, the process can be
halted and a Terminte Command Information will be signalled.
^SSTR: 16, <TermQualifier>, <TerminationCauseText>
<TerminationQualifier>
0
>0
<TerminationCauseText>
OK
Parameters
<cmdType> Number related to Proactive command or event type, see table
<status>
MC35_SAT_01_V01.01a - Preliminary
Remote-SAT interface states (refer to AT^SSTA)
"Command Type Values"). However, this information is valid during
states PAC and WAIT only.
Unsigned Integer, range 0 – 255
If <TerminationQualifier> is equal to 0, the Proactive Command has
been successfully finished.
If <TerminationQualifier> is not equal to 0 the Proactive Command
did not perform sucessfully.
If < TerminationQualifier > is not equal to 0 and
<TerminationCauseText> is not an empty string, this text has to be
shown to the user for an appropriate time, e.g. 2 seconds. The text
contains information regarding the termination cause, e.g. call
barring through Call Control by SIM mechanism.
If < TerminationQualifier > is not equal to 0 and
<TerminationCauseText> is an empty string, the TA shall give an
own indication to the user.
1.1.4 Command Type Values, pg. 7.
Command status return regarding the type of action that has taken
place, e.g. action performed by the user, possible values see the
following table 1.5.1 Remote-SAT Command Status, pg. 41.
Page 39 of 64 15.11.2001