Sstn Remote-Sat Notification - Siemens MC35 Terminal User Manual

Remote-SAT User's Guide
P R E L I M I N A R Y

1.3 ^SSTN Remote-SAT Notification

Proactive Every time the SIM application issues a proactive command, via the ME, the TA
Commands will receive a notification. This indicates the type of proactive command issued.
AT^SSTGI must then be used by the TA to request the parameters of the
proactive command from the ME.
Upon receiving the ^SSTGI response from the ME, the TA must send AT^SSTR
to confirm the execution of the proactive command and provide any required user
response e.g. selected menu item.
Unsolicited result code
^SSTN: <cmdType>
Parameters
<cmdType>
Proactive command ID, see Table 1- Command Type Identifiers
Note:
Only one proactive command can be ongoing at any one time.
Terminate When the SIM application has issued a proactive command, via the ME, to the
Proactive TA, it is possible that this command must be terminated. The ^SSTN Unsolicited
Command Result Code is sent but with a different command type (add terminate offset 100),
to indicate the termination of the specified command.
The state changes to idle.
The TA should then avoid sending any further commands related to the
terminated proactive command, e,g. AT^SSTGI or AT^SSTR.
Unsolicited result code
^SSTN: <cmdTerminateValue>
Parameters
<cmdTerminateValue> is defined as <cmdType> + terminate offset. The
terminate offset equals 100.
Terminate proactive command ID, see Table 1- Command Type Identifiers
SIM Notification to the TA when the SIM Application has finished a command cycle
Application and again enters its main menue, which was transferred with an URC ^SSTN: 37
returns to (SET UP MENU) at start up.
main menu
This URC should be used to open this menue on the sreen.
The TA does not need to respond directly, i.e. AT^SSTR is not required.
Unsolicited result code
^SSTN: <254>
Reference Note
Siemens
MC35_SAT_01_V01.01a - Preliminary Page 21 of 64 15.11.2001