Safety And Regulatory Information - Cambium Networks PMP 450i User Manual

PMP Synchronization Solutions User Guide

Safety and regulatory information

This section describes important safety and regulatory guidelines that must be observed by personnel
installing or operating Cambium wireless equipment.
Important safety information
To prevent loss of life or physical injury, observe the safety guidelines in this section.
Power lines
Exercise extreme care when working near power lines.
Working at heights
Exercise extreme care when working at heights.
Grounding and protective earth
Units must be properly grounded to protect against lightning. It is the user's responsibility to
install the equipment in accordance with national regulations. In the USA, follow Section 810 of
National Electric Code, ANSI/NFPA No.70-1984
the
Canadian Electrical Code
outdoor unit, mast, lead-in wire and discharge unit, size of grounding conductors and connection
requirements for grounding electrodes. Other regulations may apply in different countries and
therefore it is recommended that installation of the outdoor unit be contracted to a professional
installer.
Powering down before servicing
Always power down and unplug the equipment before servicing.
Primary disconnect device
The AP, SM, or BHs unit's power supply is the primary disconnect device.
External cables
Safety may be compromised if outdoor rated cables are not used for connections that will be
exposed to the outdoor environment.
PMP-0297 007v001 (January, 2017)
. These codes describe correct installation procedures for grounding the
(USA). In Canada, follow Section 54 of the
i