Ugps Installation Procedure; Figure 79 Configuring The Sync Input And Disabling Ugps Power - Pmp 100/400/430 And Ptp 100/200 Series; Figure 80 Configuring The Sync Source - Pmp 320 Series - Cambium Networks PMP 450i User Manual

PMP Synchronization Solutions User Guide

UGPS Installation Procedure

Use the following procedure to install the UGPS module and to verify operation.
Procedure 17 UGPS installation – external-powered
1
Pole mount or surface mount the GPS antenna following the installation
guidelines and specifications listed in this chapter.
2
For PMP 100/400/430/450 and PTP 100/200 series, configure (via web
management interface) the access points/backhaul masters to sync to received
GPS signal (via the timing port). Navigate to Configuration > General and set the
Sync Input to Sync to Received Signal (Timing Port/UGPS). Since the UGPS will
be configured with an external power source, set the UGPS Power value to
Disabled.
Figure 79 Configuring the sync input and disabling UGPS power - PMP
For PMP 320 series, configure (via web management interface) the access point
to sync to received GPS signal (via the AP's RJ-11 port). Navigate to
Configuration > Settings and set the Sync Source to UGPS and Serial Type to
uGPS.

Figure 80 Configuring the sync source - PMP 320 series

PMP-0297 007v001 (January, 2017)
100/400/430 and PTP 100/200 series
UGPS Installation Procedure
4-18