Register And Upgrade - Launch Creader 971 User Manual

LAUNCH
1) Locate the device USB port.
2) Use the power adaptor to connect the device with the power supply.
2. By the USB cable
1) Locate the device USB port.
2) Use the USB cable to connect the device with the computer.
Note: To get a best device performance, please keep the device fully charged. Charge the device at least 2
hours before first use.
3) After charging, press the power button to start the device.
Power supplied by DLC
This TPMS diagnostic tool can be powered by vehicle DLC (Data Link Connector) in addition to the
rechargeable battery. Follow the steps to start the device:
1. Connect one end of the diagnostic main cable to the diagnostic interface of the device and tighten the screw.
2. Locate the vehicle DLC position. The DLC is usually a standard 16 pin connector. It is an interactive
interface between the diagnostic tool and the onboard computer. In most vehicles, the DLC is installed on the
driver side, 12inch under the instrument, see below picture.
3. Insert one end of the diagnostic main cable to the vehicle DLC.
4.
Press the power button to start the device and wait for the main menu.
VII. Register and Upgrade

Register and Upgrade

Requirement:
1. Log in http://www.dbscar.com
2. Compatible operation systems: Windows XP, 7, 8 or Windows 10.
This TPMS diagnostic tool supports 2 upgrade methods. Select any one of them to upgrade:
Method 1: Via Memory card (recommended)
1. Start the upgrade tool, screen displays as shown in the below picture:
to download the upgrade tool and install it to the computer.
16
Creader 971 User's Manual