Fault History Menu - Honeywell SmartVFD COMPACT User Manual

Honeywell

8.4.5 Fault history menu

READY RUN
REF
MON
PAR
FLT
FWD REV
READY RUN
REF
MON
PAR
FLT
FWD REV
Figure 8.6: Fault history menu
In Fault history menu you can browse through 9 latest faults (see Figure 8.6). If a fault
is active, the relevant fault number (e.g. F1 02) alternates in the display with main
menu. When you browse between the faults, the fault codes of active faults are blink-
ing. The active faults can be reset by pressing the STOP button for 1 second. If the
fault cannot be reset, the blinking continues. It is possible to navigate in the menu
structure also when there are active faults present, but the display returns automati-
cally to the fault menu if buttons or navigation wheel are not pressed or navigation is
not rotated. The operating hour, minute and second values at the fault instant are
shown in the value menu (operating hours = displayed reading x 1000 h).
See Chapter 6 in for fault descriptions
62-0312—02
Control Panel
STOP ALARM FAULT
I/O KEYPAD BUS
STOP ALARM FAULT
I/O KEYPAD BUS
Note! The whole fault history can be cleared
by pressing STOP button for 5 sec time when
the drive is stopped and Fault history menu
is selected in the display.
READY RUN
REF
MON
PAR
FLT
Push
FWD
Browse
faults 1-9
READY RUN
REF
MON
PAR
FLT
Push
FWD
Browse
for hours (H),
minutes (M)
and seconds (S)
STOP ALARM FAULT
REV I/O KEYPAD BUS
STOP ALARM FAULT
REV I/O KEYPAD BUS
40
8