Table of Contents
Advertisement
Honeywell
8.3 KEYPAD
The keypad section of the control panel consists of a navigation wheel and START
and STOP buttons (see Figure 8.1). The navigation wheel is used for navigating on
the panel display, but it also works as a reference potentiometer when KEYPAD has
been selected as the control place of the drive. The wheel has two separate func-
tions;
- rotating the wheel e.g. for changing parameter value (12 steps / round)
- pressing the wheel e.g. for accepting the new value.
The drive stops always, regardless of the selected control place, by pressing the key-
pad STOP button. The drive starts by pressing the keypad START button, but only
if the selected control place is KEYPAD.
62-0312—02
Control Panel
Figure 8.1: Control panel
34
8
Advertisement
Table of Contents
