Wlan Module - HP ENVY 17m Maintenance And Service Manual

WLAN module

Description
WLAN module
11 AC+Bluetooth INT 7265NV M.2 D1 MOW
RT CARTIER AC 2X2
IMPORTANT:
replacement
CAUTION: To prevent an unresponsive system, replace the wireless module only with a wireless module
authorized for use in the computer by the governmental agency that regulates wireless devices in your
country or region. If you replace the module and then receive a warning message, remove the module to
restore device functionality, and then contact technical support.
Before removing the WLAN module, follow these steps:
1. Shut down the computer.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the following components:
a. Base enclosure (see
b. Battery (see
c. Hard drive (see
d. Solid-state drive (see
e. Memory (see
Remove the WLAN module:
1. Disconnect the WLAN antenna cables (1) from the terminals on the WLAN module.
NOTE:
The WLAN antenna cable labeled "2" connects to the WLAN module "Aux" terminal labeled "2".
2. Remove the Phillips screw (2) that secures the WLAN module to the system board. (The WLAN module
tilts up.)
Make special note of each screw and screw lock size and location during removal and
Base enclosure on page
Battery on page
Hard drive on page
Solid-state drive on page
Memory on page
The WLAN antenna cable labeled "1" connects to the WLAN module "Main" terminal labeled "1".
26).
28).
31).
33).
35).
Spare part number
901229-855
924813-855
Component replacement procedures 37