Analogue Inputs Display; Digital Input Display; First Switch On - Eliwell Memory 1000 Manual

2.3.1.1 Analogue inputs display

All analogue inputs are shown with the following information:
• Name of analogue input P1, P2,...P8**.
- ONBOARD Px if the resource is integrated (see section 4.4 Onboard
Resources).
- Px for Televis network resources (see section 4.5 Network 1).
• Value (2 figures with decimal point indicating tenths of a degree ) or Probe Error.
• Unit of measure (C degrees centigrade; Bar pressure in bar; etc.).
• Alarm condition.

2.3.1.2 Digital input display

All digital inputs are shown with the following information:
• Name of digital input D1, D2**.
- ONBOARD Dx if the resource is integrated (see section 4.4 Onboard
Resources).
- Dx for Televis network resources (see section 4.5 Network 1).
• State (active/not active).
• Alarm condition.
** The number of resources depends on the system settings and model.

2.3.1.3 First switch on

This page appears when the device is switched on for the first time.
After this, you can access this menu from menu 4 - Standard Configuration
(sub-menu 4.0 First Switch On and "force" the First Switch On function.
9MA10011
* FIRST SWITCH ON *
Language
AAAA/MM/GG:
HH:MM:SS:
Period REC.
EN12830:
Num. of probes used:
Num. of digits used:
It is highly recommended to configure:
• Date (yy/mm/dd) format and time (hh:mm/ss).
• Recording period, expressed in minutes.
Value REC period
000
001
002
...
099
100
Based on the recording period set, line below shows the degree of conformity with
UNI EN 12830 in real time.
English
<date>
<hour>
min : 000
<=24h / 30s
8
2
30 seconds
1 minute
2 minutes
...
99 minutes
100 minutes

|
|
|
|
|
|

9/52