Table of Contents
Advertisement
10. MECHANICAL ASSEMBLY
Memory 1000 was designed for wall or panel-mounting (support brackets not
supplied).
Remove the screw caps on the right side of the door, pressing lightly on the points
indicated by the arrows in Figure 1. Take out the screws and open the door. Drill
holes in the backplate at the top or bottom to pass the wires through. See the
example in figure 2:
Fig. 1
Screw the backplate to the wall using 4 screws (not supplied) to match the holes
illustrated in figure 3.
9MA10011
Fig. 2
LOW
HIGH
Shut the door by securing it with 2 screws (provided). Replace the screw caps
removed earlier from the door (see point 1).
Drill holes in
these points
Fig. 3
Hole A
Hole B
Hole C
Hole D
41/52
Hide quick links:
Advertisement
Table of Contents
