Download Data With Sd Card; Printer Errors - Eliwell Memory 1000 Manual

6.6 Printer Errors

At the start of or during a print job, a number of problems may occur with the
printer. These have been listed in the table below:
Message CAUSE
No data to
print
Printer LED Out of paper
blinking
Printer LED Printer not
blinking connected
Printer LED Printer error
permanently
on
Printer LED Print job
permanently suspended
on manually
9MA10011
EFFECTS REMEDY
No print
No print Replace paper roll
No print
No print
Print Take out the paper
suspended roll and repeat the
print procedure.
The new version of the Memory 1000 has a new fast data download function
via SD CARD.
NOTE: The SD CARD must be at least 2GB and be previously formatted
with FAT12, FAT16 or FAT32.
N.B.
Enter the SD CARD in the slot (see Fig. 1), Memory 1000 will recognize it
automatically and the words "SD CARD In" will appear on the display.
Once the controller has recognized it and checked it has been formatted, it will
immediately start to download data. Data will be downloaded to this folder:
where "xxxxxxxx" is a unique 8-figure code identifying the Memory 1000.
During downloading, 'Downloading Data' appears on the display.
Once downloading is complete, 'SD CARD Out' appears on the display.
LED
permanently
on
At this point, the SD CARD can be removed and read by a PC.
The data downloaded can be imported by the same software used for downloading
via the serial port on the controller.
NOTES:
1) The MMDATA directory will be created automatically if it does not
already exist.
2) Data will be grouped into 64k byte files with a sequential number
identifying the chronological order in which they were saved.
3) Never try to remove the SD CARD when data is downloading as this
could corrupt the data or damage the CARD.

7. DOWNLOAD DATA WITH SD CARD

\\MMDATA\xxxxxxxx\BIN
fig.1
32/52