Configuring The Device To Output Debugging Messages To The Console - Huawei AR530 Series Configuration Manual

Huawei AR530&AR550 Series Industrial Switch Routers
Configuration Guide - Device Management
Step 4 (Optional) Run:
info-center logfile path path
The path where log files are saved is specified.
Step 5 (Optional) Run:
info-center logfile size size
The log file size is set.
By default, the log file size is 8 MB.
Step 6 (Optional) Run:
info-center max-logfile-number filenumbers
The maximum number of log files that can be saved is set.
By default, a maximum of 200 log files can be saved.
If the number of log files generated on the Router exceeds the limit, the system deletes the oldest
log file.
----End

3.5.3.5 Configuring the Device to Output Debugging Messages to the Console

Context
After debugging messages are output to the console, you can view debugging messages on the
console (host from which you can log in to the device through the console interface) to monitor
device running.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
info-center console channel { channel-number | channel-name }
A channel used by the device to output debugging messages to the console is specified.
By default, the device uses channel 0 to output debugging messages to the console.
Step 3 Run:
info-center source { module-name | default } channel { channel-number | channel-
name } debug { state { off | on } | level severity }
Issue 01 (2014-11-30)
NOTE
By default, log files are stored in the flash memory.
NOTE
If the size of a log file generated on the device exceeds the configured log file size, the system decompresses
the log file into a zip file.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Information Center Configuration
*
45